Sometimes things happen and you eventually have to replace a part in your car. The bumper is probably one of the easiest. Here, we’ll show you how to swap the old with the new.

You did not read that wrong, this is a simple DIY for extending the strut extenders that came with your BC Racing coilovers.
Read along to see how i did it.

There are many ways to customize your grille, some take it apart and paint it, others apply CF wrap, while others just go and purchase one from Infiniti or some aftermarket supplier. Here’s yet another way to do it, the quick ‘n easy way.

Here’s a little how-to on replacing the battery on the G. It’s literally a sub-20 minute job. It’ll probably take you longer to go out and buy the battery from your local store.

In-cabin filters help clean the air that goes in to your vehicle. Some cabin filters like the one i reviewed here (and used below) is also Carbon-activated, which means it also absorbs and helps reduce odor inside the cabin.
With the filter in hand, and 30 minutes of your time (at the very most), you can [...]

A grounding kit basically does just that, it improves the grounding on your vehicles electronic system. There are some benefits to be had, and in these days of ECU’s and ICE (In-Car-Electronics) it makes sense that improving on the grounds will help optimize these systems. Here’s a simple how-to on installing a kit from one [...]

Applying the rear valence overlay is a rather simple process, although i have to admit that the first time around i rushed it - as such i was left with a lot of creases and a good number of bubbles. Patience is the key here.

Low-profile racing ramps and jacks are rather pricey for the weekend warrior, and as far as jack’s go even low-profile versions have a hard time reaching the front jack points on a 2nd generation G sedan.
So, off to Homedepot i went. About $15 and 20 minutes later, this is what i came up with.